| [Back to Index] | ||
| Full set the system | ||
| 1. | Enter [User code] | Exit tone sounds |
|---|---|---|
| Part set the system | ||
| 1. | Press [2] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | |
| Unset the system | ||
| 1. | Enter [User code] | Entry tone stops |
| Reset system after alarm condition | ||
| 1. | Enter [User code] | |
| Omit a zone | ||
| 1. | Enter [User code] | |
| 2. | Press [OMIT] | |
| 3. | Press [Zone number to omit] | Zone is omitted |
| 4. | Repeat above two steps as required for addition zones | |
| Change your own user code | ||
| 1. | Press [4] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | |
| 4. | Enter existing [user to change] | Defaults user codes are 0001 to 0007 for users 2 to 8, and [OMIT] [OMIT] [OMIT] [OMIT] for the duress code (all inactive!) |
| 5. | Enter new [User code] | |
| Test the alarm sounders | ||
| 1. | Press [8] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | Sounders should sound |
| Walk test the detection devices | ||
| 1. | Press [9] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | Walk test detectors as required - sounder tone changes to indicate detector active |
| 4. | Enter [ENT] to end test | |
| Keypad personal attack alarm | ||
| 1. | Press [1] and [3] together | Personal attack alarm generated |
| View the event log | ||
| 1. | Press [5] | |
| 2. | Press [ENT] | |
| 3. | Enter [User code] | |
| 4. | Press [4] for earlier events, [6] for later event | |
| [Back to Index] | ||